Buick square drive balancer bolts
Installation Instructions
Part Number: 120-2502
Application: BUICK V6 & V8
Harmonic Balancer Bolt - Installation
[1]
Please check the part-number(s) for your
application against the part-number(s) listed on
the instruction sheet.
[2]
Clean and inspect all hardware prior to
installation. Look for obvious defects or shipping
damages, plus proper fit, length and dimension.
[3]
To ensure proper thread engagement and
accurate torque readings, clean the threads in
the end of the crankshaft. Chase if necessary
with a Thread Chaser or Tap.
[4]
Lubricate the threads of the bolt, the underhead
of the bolt and the front face of the balancer
(where the washer contacts the balancer) with
ARP ULTRA-TORQUE FASTENER ASSEMBLY
LUBRICANT. Then install the washer onto the
bolt and install the bolt hand tight.
[5]
Tighten the balancer bolt to 200 ft-lbs (271.2 Nm) using
ARP ULTRA TORQUE FASTENER ASSEMBLY
LUBRICANT.
If you have any questions or need additional information
please contact us at (805) 339-2200 or by FAX at (805)
650-0742.
⚠ This is an automatically generated translation and unit conversion. Always refer to the original ARP instruction sheet for exact specifications. Errors may occur.
Heb je het artikel niet gevonden of heb je vragen? Neem gerust contact met ons op!
App ons direct via WhatsApp!
Stuur een berichtje naar 06‑30169408 en ontvang snel een persoonlijk antwoord.
WhatsApp is handig en snel, en je kunt eenvoudig foto’s of bestanden meesturen.
Geen wachttijd, gewoon direct contact.
We helpen je graag verder!
