This is the best way to increase the performance of your stock calipers without going for a Big Brake kit to go. The kit will eliminate caliper twisting caused by the stock rubber guide pin bushings. The results are very noticeable, even brake pad wear decreases and it provides a more constant braking feeling. Brass is very wear-resistant and therefore ideally suited for this part.
Our V2 kit has dust caps, longer bushings and a viton o-ring. This provides a more durable bush that is less sensitive to brake dust, making it more suitable for street use than the original kit
In produced in-house from high quality wear-resistant brass with extremely precise tolerances for optimal fit and operation.
With the o-ring, these are suitable for a little copper grease on the inside of the brass bush.
Fits all BMW factory ATE brake calipers (front and/or rear) (E81-E88, E30-F30, E28-F18, E24-F13, E23-F04, E31, E53-F15, Z1 Z3 E52-E89). To be sure, check for ATE on the sliding caliper. (or check with the BMW part no)
WILL NOT FIT: Girling E30 318/325 calipers, E28M5, E24M6, 850csi,E9x M3, 135i optional 6-piston calipers. E6* M5/M6 front axle
Kit is for 1 pair of calipers. So order 2 if you want to replace the front and rear.
Replacement / performance of race part.
BMW part nr: 34 11 1 157 038
Heb je het artikel niet gevonden of heb je vragen? Neem gerust contact met ons op!
App ons direct via WhatsApp!
Stuur een berichtje naar 06‑30169408 en ontvang snel een persoonlijk antwoord.
WhatsApp is handig en snel, en je kunt eenvoudig foto’s of bestanden meesturen.
Geen wachttijd, gewoon direct contact.
We helpen je graag verder!
